Using your QUATECH DSP-100 PCMCIA card with SI-SCOPE

SI_SCOPE has built in support for your QUATECH dual port card. Before using your card with SI_SCOPE please follow the directions in Section1 and then proceed to Section 2.

Section 1:

1. Install the Quatech drivers from the driver disk that came with your Quatech card. Refer to the documentation included on your Quatech CD for more details.
2. Verify that your card is working using HyperTerm or a similar program.
3. Open Device Manager on your system and double click on the entry titled “Quatech Multiport Serial Devices”
4. Locate the entry for your card and double click on it.
5. On the next dialog box click on the resources tab and write down the values for the Interrupt Request and Input/Output Range.
6. Click “Cancel”

Section 2:

Now you are ready to launch SCOPECFG from the Windows Start Menu. After the program loads follow these steps:

1. Select the Settings->Configure Port Parameters menu option.
2. In the Port1 Address field enter the value recorded for the Input/Output range from section 1 step 5 above.
3. In the Port1 IRQ field enter the value recorded for the Interrupt Request from section 1 step 5 above.
4. Add eight to the value in the Port1 Address field and enter that value in the Port2 Address field.
5. Enter the value for the Port1 IRQ field into the Port2 IRQ field and click Accept.
6. Select the Settings->Configure Board Type menu option.
7. From the “Multiport Board Configuration” dialog choose your Quatech card type from the drop down menu.
8. Leave the Base Address set at zero and click Accept.
9. Select the Settings->Configure Virtual Driver menu option.
10. From the Configure SI-SCOPE Device Driver dialog enable the Claim Hardware During O/S Load option and click Accept.
11. Save your settings and reboot your PC.

Back to Tech Help

Send mail to webmaster@sinnovations.com with questions or comments about this web site.
Copyright © 1999-2007 Software Innovations Inc.

This page last updated on 10/03/2007